Chapter 2
Basic Operation
2.1
Powering On and Off
1
Press the Power switch of the controller enclosure.
Power switch
The POWER LEDs on the controller enclosure and the drive enclosures are turned on.
2
After approximately five minutes (or approximately 10 minutes for a Unified configuration and approxi-
mately 20 minutes for a VLAN/Bonding maximum configuration), check that the READY LED of the con-
troller enclosure is lit up.
2.1.4
Powering Off
This section explains how to turn off the ETERNUS DX.
To turn off the ETERNUS DX, perform one of the procedures below.
Via power switch
•
Press the Power switch to turn off the ETERNUS DX.
Via ETERNUS Web GUI or ETERNUS CLI
•
Use ETERNUS Web GUI or ETERNUS CLI to turn off the ETERNUS DX.
The following methods can be used to turn off the power by linking with the server.
Via the power synchronized unit
•
Use the power synchronized unit to turn off the ETERNUS DX.
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Operation Guide (Basic)
Controller enclosure
Drive enclosure
Controller enclosure
56
Copyright 2017 FUJITSU LIMITED
P3AM-7662-09ENZ0