Fujitsu ETERNUS DX100 S4 Basic Operation Manual page 59

Chapter 2 Basic Operation
2.2 Using the FUNCTION Button
3
Use the FUNCTION button to change settings.
• Switching the Master CM to the other controller when two controllers are installed
Use the pin to push down the FUNCTION button twice within three seconds.
The MASTER LED for the controller that is set as the Master CM is green.
Restoring the factory default settings of the LAN ports
•
Use the pin to push down the FUNCTION button three times within three seconds.
After the default settings of the LAN ports are restored, the MAINTENANCE LED blinks green a few
times a second for several seconds.
Restoring the factory default user settings
•
(1)
Remove all the LAN cables from the LAN ports (MNT ports and RMT ports) of all the controllers.
(2)
Use the pin to push down the FUNCTION button five times within three seconds.
After the default user settings are restored, the MAINTENANCE LED blinks green approximately every
second for several seconds.
4
Release maintenance status.
Use the pin to push down the FUNCTION button for three seconds.
The MAINTENANCE LED turns off, which indicates that the ETERNUS DX is no longer in maintenance sta-
tus.
5
Attach the flange cover.
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Operation Guide (Basic)
59
Copyright 2017 FUJITSU LIMITED
P3AM-7662-09ENZ0