Installing An Air Filter On A 12518E - HP FlexFabric 12500E Installation Manual
Routing switch
Hide thumbs
Also See for FlexFabric 12500E:
- Configuration manual (92 pages) ,
- Network management and monitoring command reference (320 pages) ,
- Command reference manual (157 pages)
Table of Contents
Advertisement
Figure 12 Installing an air filter
Installing an air filter on a 12518E
1.
Use a Phillips screwdriver to loosen the screws at both sides of the plastic panel and remove the
panel.
2.
Insert the air filter into the rear of the chassis along the slide rails, and then fasten the screws at both
sides of the air filter.
Figure 13 Installing an air filter
Installing the switch in a rack
CAUTION:
When moving the switch, hold the handles at both sides of the chassis. Do not hold the plastic panel of the
chassis, the handle of the fan tray, the handle of the back cover of the chassis, or the air vents of chassis.
Any attempt to carry the switch with these parts might cause equipment damage or even bodily injury.
Installation preparation
Confirm the following preparations before starting installation:
19
Advertisement
Table of Contents
