Managing The Power Supply System - HP FlexFabric 12500E Installation Manual

You can reboot the switch in one of the following ways:
• Power off and then power on the switch. This method might cause data loss, and is the
least-preferred method.
Immediately reboot the switch at the CLI.
Schedule a reboot at the CLI, so the switch automatically reboots at the specified time or after the
•
specified period of time.
The first method is called "cold reboot" or "cold startup". The second and third methods are called
"warm reboot" or "warm startup", and can be used remotely.
For data security, if you reboot the switch while the switch is performing file operations, the switch does
not reboot.
The precision of the rebooting timer is 1 minute. One minute before the rebooting time, the switch
prompts "REBOOT IN ONE MINUTE" and reboots in one minute.
To reboot cards or switches immediately at the CLI, execute one of the following tasks as needed in user
view:
Task
In standalone mode, reboot a
card, or the switch
immediately.
In IRF mode, reboot an IRF
member switch, a card on the
switch, or all IRF member
switches.
To schedule a reboot, execute either of the following commands in user view:
Task
Specify the reboot date and
time.
Specify the reboot delay time.

Managing the power supply system

You can use the following display commands and proper configuration commands to manage the power
supply system of your switch.
Displaying the electrical label data for the power monitor
module
Use the display device manuinfo power-monitor command to display the electrical label data for the
specified power monitor module, including the module name, serial number, manufacturing date, and
vendor name.
• In standalone mode:
Command
reboot [ slot slot-number ] [ force ]
reboot [ chassis chassis-number
[ slot slot-number ] ] [ force ]
Command
schedule reboot at time [ date ]
schedule reboot delay time
54
Remarks
If you reboot the active MPU or do not
specify the slot keyword, the reboot
command reboots the switch.
If you reboot the active MPU or do not
specify the slot keyword, the reboot
command reboots the member switch.
Remarks
By default, the reboot date and time is
not specified.
By default, the reboot delay time is not
specified.