HP FlexFabric 12500E Installation Manual page 97

Card
LST1GT48LEB1
LST1GT48LEC1
LST1FW2A1
LST1FW3A1
For more information about the 12500E cards, see the relevant datasheet of the cards.
MPUs
CAUTION:
• HP recommends that you install two MPUs on a switch for redundancy. If two MPUs are installed, their
model must be the same. Otherwise, the standby MPU cannot start up.
The USB ports on the MPU can be used only to connect to storage media such as USB disk, and cannot
•
be used to charge external equipment. Otherwise, the MPU might fail.
The length of the USB cable used for the LST1MRPNE1 must be less than 4 m (13.12 ft).
•
Table 28 MPU specifications
Item
Model
Flash
BootWare
NVRAM
SDRAM
CF card
Interfaces
NOTE:
The MCC GE port is supported only in Release 73xx or later.
Switching fabric modules
IMPORTANT:
Use the switching fabric modules of the same model on a 12500E.
Power consumption
110 W to 175 W
115 W to 190 W
90 W to 120 W
128 W to 168 W
Specifications
LST2MRPNC1
128 MB
4 MB
1 MB
4 GB
1 GB
•
1 console port
•
1 AUX port
•
1 network management port
•
1 CF card slot
•
2 USB ports—HOST and DEV (DEV is not
supported)
•
2 MCC GE ports
Net weight
4.25 kg (9.37 lb)
4.44 kg (9.79 lb)
4.36 kg (9.61 lb)
4.80 kg (10.58 lb)
LST1MRPNE1
512 MB
8 MB
1 MB
8 GB
4 GB
•
1 console port
•
1 USB console port
•
1 network management port
•
1 ECP port (reserved)
•
1 CF card slot
•
1 USB ports
•
2 MCC GE ports
91
Dimensions (H × W × D)
40 × 400 × 467 mm (1.57 ×
15.75 × 18.39 in)
40 × 400 × 467 mm (1.57 ×
15.75 × 18.39 in)
40 × 400 × 467 mm (1.57 ×
15.75 × 18.39 in)
40 × 400 × 467 mm (1.57 ×
15.75 × 18.39 in)