Installing Optional Components; Installing An Air Filter - HP FlexNetwork HSR6802 Installation Manual

2. Insert the CF card into the slot following the direction shown in
not project from the slot.
Figure 17 Inserting the CF card into the slot

Installing optional components

Optional components (including the air filter and lightning protectors) are not provided with the router.
Purchase them if necessary.

Installing an air filter

Installing an air filter on an HSR6802/HSR6804
The methods for installing air filters on the HSR6802 and HSR6804 are the same. This section uses
an HSR6804 as an example.
To install an air filter:
1. Face the left side (side of the inlet vents) of the router.
2. Install the upper and lower slide rails on the chassis as shown in
3. Use a Phillips screwdriver to fasten the fastening screws on the upper and lower slide rails.
Figure 18 Installing the upper and lower slide rails
4. Push the air filter along the slide rails from the rear side of the chassis to the front.
18
Figure 17, and make sure it does
Figure 18.