HP FlexFabric 12500E Installation Manual page 74

Field
RX power low
TX power high
TX power low
TX bias high
TX bias low
Temp high
Temp low
Voltage high
Voltage low
Transceiver info I/O error
Transceiver info checksum error
Transceiver type and port configuration mismatch
Transceiver type not supported by port hardware
XFP
RX loss of signal
RX not ready
RX CDR loss of lock
TX fault
TX not ready
TX CDR loss of lock
Module not ready
APD supply fault
TEC fault
Wavelength unlocked
RX power high
RX power low
TX power high
TX power low
TX bias high
TX bias low
Temp high
Temp low
Voltage high
Voltage low
Remarks
The received optical power is low.
The transmitted optical power is high.
The transmitted optical power is low.
The transmitted bias current is high.
The transmitted bias current is low.
The temperature is high.
The temperature is low.
The voltage is high.
The voltage is low.
Transceiver information read and write error
Transceiver information checksum error
The type of the transceiver module does not match the
port configuration.
The port does not support this type of transceiver
modules.
Received signals are lost.
The receiving status is not ready
Receiving CDR loss of lock.
Transmission error.
The transmission status is ready.
Transmission CDR loss of lock.
The module is not ready.
Avalanche Photo Diode (APD) supply error.
Thermoelectric Cooler (TEC) error.
Wavelength loss of lock.
The received optical power is high.
The received optical power is low.
The transmitted optical power is high.
The transmitted optical power is low.
The transmitted bias current is high.
The transmitted bias current is low.
The temperature is high.
The temperature is low.
The voltage is high.
The voltage is low.
68