HP FlexFabric 12500E Installation Manual page 72

Task
Display key parameters of the transceiver
in a specified interface
Display part of the electrical label
information of transceiver in a specified
interface
# Display the main parameters of the transceiver plugged in interface GigabitEthernet 3/0/3.
<Sysname> display transceiver interface gigabitethernet 3/0/3
GigabitEthernet3/0/3 transceiver information:
Transceiver Type
Connector Type
Wavelength(nm)
Transfer Distance(m)
Digital Diagnostic Monitoring : YES
Vendor Name
Ordering Name
Table 20 Command output
Field
Connector Type
Wavelength(nm)
Transfer distance(xx)
Digital Diagnostic
Monitoring
Ordering Name
Command
display transceiver interface [ interface-type interface-number ]
display transceiver manuinfo interface [ interface-type
interface-number ]
: 1000_BASE_SX_SFP
: LC
: 850
: 550(50um),270(62.5um)
: HP
: JD118B
Description
Type of the connectors of the transceiver:
•
SC—Fiber connector, developed by NTT
•
LC—1.25 mm/RJ-45 optical connector developed by Lucent.
•
RJ-45
•
CX 4
•
Fiber transceiver—Central wavelength (in nm) of the laser sent. If the
transceiver supports multiple wavelengths, every two wavelength values are
separated by a comma.
•
Copper cable—Displayed as N/A.
Transfer distance, where "xx" represents the distance unit: km (kilometers) for
single-mode transceivers and m (meters) for other transceivers.
If the transceiver supports multiple transfer medium, every two values of the
transfer distance are separated by a comma. The transfer medium is included in
the bracket following the transfer distance value. The following are the transfer
media:
•
9 um—9/125 μm single-mode optical fiber
•
50 um—50/125 μm multi-mode optical fiber
•
62.5 um—62.5/125 μm multi-mode optical fiber
•
TP—Twisted pair
•
CX4—CX4 cable
Support for the digital diagnosis function:
•
YES—Supported
•
NO—Not supported
Product code.
66