HP FlexFabric 12500E Installation Manual page 45
Routing switch
Hide thumbs
Also See for FlexFabric 12500E:
- Configuration manual (92 pages) ,
- Network management and monitoring command reference (320 pages) ,
- Command reference manual (157 pages)
Table of Contents
Advertisement
Connection procedure
Figure 36 Connecting through the console port and the serial port
To connect the console cable through the console port:
1.
Connect the DB-9 connector of the console cable to the serial port on a PC or terminal.
2.
Connect the RJ-45 connector of the console cable to the console port on the MPU of the switch.
To connect the console cable through the USB console port:
3.
Connect the USB-A connector of the console cable to the USB port on a PC or terminal.
4.
Connect the mini-USB A/B connector of the console cable to the USB console port on the MPU of
the switch.
NOTE:
If two MPUs are installed on the switch, log in through the console port or USB console port on the active
•
MPU (typically with a smaller slot number) for the first login.
When you remove the console cable, first disconnect the switch end, and then disconnect the PC end.
•
39
Advertisement
Table of Contents
