HP FlexFabric 12500E Installation Manual page 58

1/18 LST1SF08E1
Table 13 Command output
Field
Slot No.
Brd Type
Brd Status
Software Version
# In standalone mode, display information about the card in slot 5.
<Sysname> display device slot 5
Status : Normal
Type : LST1XP48LFD1
Software : 12500-CMW710-R7328
PCB : Ver.A
Board Cpu:
Number of Cpld: 2
Cpld 0:
SoftWare : 001C
Cpld 1:
SoftWare : 001C
CpuCard
Type : LSR1CPA
PCB : Ver.C
Number of Cpld: 1
Cpld 0:
SoftWare : 001
Normal
Description
•
In standalone mode:
Slot No.—Slot number of a card.
•
In IRF mode:
Slot No.—Slot number of a card on the specified member switch in the format of
member ID/slot number.
Hardware type of a card, which can be:
•
Specific card model—Type of a card (such as LST1MRPNE1), which is the same as
the silkscreen.
•
NONE—No card is in the slot.
•
UNKNOWN—The card is not supported by the software version and thus cannot
start properly.
Card status, which can be:
•
Absent—No card is in the slot.
•
Master—The card is an active main processing unit (MPU).
•
Standby—The card is a standby MPU.
•
Normal—The card is operating properly.
•
Fault—The card in the slot has not started up or has failed.
•
Off—The card is not powered on.
•
Illegal—The card is not supported by the software version and thus cannot start
properly.
Software version of the current card, which can be:
•
Specific software version.
•
NONE—No card is in the slot.
•
Mismatched—The software version does not support the card and thus cannot be
uploaded.
52
12500-CMW710-R7328