Figure 85 Affixing a label
TO:
–
B03
48V2
Bind cable ties on both ends of a cable. After the bundling, the finished identification plate should be on
top of the cable in horizontal cabling, or on the right side of the cable in vertical cabling. Make sure the
label is facing out, as shown in
Figure
86.
Figure 86 Affixed labels
Affixing a generic label
The requirements for affixing a generic label are the same as affixing a label on a signal cable. For more
information, see
"Affixing a label to a signal
cable." For the example of affixed labels, see
Figure
84.
119