Check/Change The Node Id Of A Module - GE ÄKTA pure Operating Instructions Manual

8.3

Check/Change the Node ID of a module

Introduction
Node ID is a unit number designation that is used by the instrument to distinguish be-
tween several units of the same type. All standard valves and available optional modules
are pre-configured to give the desired function. However, the function of a valve or
module can be changed by changing the Node ID. Also, in a troubleshooting situation
it may be useful to check a valve's or module's Node ID.
Note:
Node ID for core modules
The table below lists the Node ID for the core modules.
Core module
System pump A
System pump B
Pressure monitor
Mixer
Injection valve
Node ID for optional modules
The table below lists the Node ID for the optional modules.
Module
Inlet valve A
Inlet valve B
Inlet valve AB
Inlet valve X1
Inlet valve X2
Mixer valve
ÄKTA pure Operating Instructions 29-0229-97 AE
The function of a valve or module is defined by its Node ID, not by its physical
position.
8 Reference information
8.3 Check/Change the Node ID of a module
Label
P9 A / P9H A
P9 B / P9H B
R9
M9
V9-Inj / V9H-Inj
Label
V9-IA / V9H-IA
V9-IB / V9H-IB
V9-IAB / V9H-IAB
V9-IX / V9H-IX
V9-IX / V9H-IX
V9-M / V9H-M
Node ID
0
1
0
0
4
Node ID
0
1
3
15
16
22
135