(5)
Remove the cover plate.
(6)
Take off the converter PC board from the logic PC board (LGC board).
(7)
Connect the 10-pin side of the harness jig for board connection to the connector (CN2) of the
converter PC board.
e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C
FIRMWARE UPDATING
Cover plate
Fig. 8-33
Fig. 8-34
CN2
Fig. 8-35
© 2008 - 2011 TOSHIBA TEC CORPORATION All rights reserved
8 - 40