Table of Contents
Advertisement
7.2
Precautions, Procedures and Settings for Replacing PC
Boards and HDD
7.2.1
Precautions when replacing PC boards
•
The ID for each equipment is registered on the LGC board, the IMG board, the SYS board and the
SLG board. So, if their replacement is required, be sure to replace only one board at a time.
•
If more than one of the LGC board, the IMG board and the SYS board require replacement, replace
them in the following procedure.
1. First, replace one of the board to be replaced.
2. Turn the power ON and confirm that "READY" is displayed.
3. Turn the power OFF.
4. Replace another board that requires replacement.
5. Repeat steps 2 to 4.
•
The LGC board and IMG board can be replaced without other settings.
•
When the HDD requires replacement, see "7.2.3Precautions and procedures when replacing the
HDD".
•
When the SYS board requires replacement, see "7.2.4Precautions and Procedures when replacing
the SYS board".
•
When the SLG board requires replacement, see "7.2.5Procedures and settings when replacing the
SLG board".
•
When SRAM requires replacement, see "7.2.6Precautions and procedure when replacing the
SRAM board (for the SYS board)" / "7.2.7Procedures and settings when replacing SRAM board (for
LGC board)".
© 2008 - 2011 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C
7 - 15
REPLACEMENT OF PC BOARDS/HDD
7
Advertisement
Table of Contents
