Table of Contents
Advertisement
[I]
Set EFI Printer Board
If the EFI Printer Board (GA-1211) is installed, perform the following procedure.
(1)
Turn the power OFF.
(2)
Start the setting mode (08).
(3)
Initialize the EFI Printer Board (08-700).
(4)
Turn the power OFF.
[J]
Reinstall options
When any of the options below was installed, reinstall a license for the corresponding option following
its unpacking instructions.
•
Meta Scan Enabler (GS-1010)
•
External Interface Enabler (GS-1020)
•
IPSec Enabler (GP-1080)
When GP-1070 (Data Overwrite Enabler) has been installed, "F200" service call occurs.
In this case, perform cancelling the "F200" service call (installing the OS / HDD SYS / PFC Firmware /
Engine MainFirmware / Scanner Firmware using the USB media), and then install GP-1070 (Data
Overwrite Enabler) again.
e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C
REPLACEMENT OF PC BOARDS/HDD
© 2008 - 2011 TOSHIBA TEC CORPORATION All rights reserved
7 - 28
Advertisement
Table of Contents
