Toshiba e-STUDIO2020C Service Handbook page 172

Multifunctional digital color systems

Hide thumbs Also See for e-STUDIO2020C:

Table of Contents

[D] Secondary scanning data laser writing start position

Performing the code 05-408 covers this adjustment for all paper sources.

The adjustment for each paper source is also available.

For all paper sources

For each paper source

Paper source

While pressing [0] and [5] simultaneously, turn the power ON. → (Adjustment Mode)

Press [98] ([3] for duplexing) → [FAX]. (A grid pattern with 10 mm squares is printed out.)

Measure the distance D from the leading edge of the paper to the 6th line of the grid pattern.

* Normally, the 1st line of the grid pattern is not printed.

* At the duplexing, measure it on the top side of the grid pattern.

Check if the distance D is within 52±0.5 mm.

If not, use the following procedure to change values and measure the distance D again.

(Adjustment Mode) → (Key in the code shown above) → [START]

→ (Key in an acceptable value shown above)

→ [ENTER] or [INTERRUPT] (Stored in memory)

→ "100% A" is displayed

→ Press [98] ([3] for duplexing)

→ [FAX] → (A grid pattern is printed out.)

* The larger the adjustment value is, the longer the distance D becomes (approx. 0.10 mm/

e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C

Acceptable value

Performs the adjustment for all paper sources.

Paper fed from the 2nd drawer