Table of Contents
Advertisement
<Procedure>
[ 0 ][ 5 ]
( Code )
[ START ]
[ Power ]
[ SET ] or
[ INTERRUPT ]
Stores in memory
(*1)
1:
Single-sided grid pattern in Black Mode
3:
Double-sided grid pattern in Black Mode
55:
Grid pattern of thick paper 2 in Full Color Mode
56:
Grid pattern of thick paper 3/thick paper 4 in Full Color Mode
57:
Grid pattern of OHP film in Full Color Mode
58:
Single-sided grid pattern of thick paper 2 in Black Mode
59:
Single-sided grid pattern of thick paper 3/thick paper 4 in Black Mode
60:
Single-sided grid pattern of OHP film in Black Mode
98:
Single-sided grid pattern in K(4)
K(4)*: System in which the test pattern is printed only in the black mode, though the four color
developers (Y, M, C, K) are contacted to the transfer belt.
Note:
If the aligning amount is too large, abnormal noise (paper-folding noise) or actual paper folding
may occur during paper feeding. If the aligning amount is too small, on the other hand, a skew,
an image dislocation in feeding direction or a paper exit jam (E010) may occur. Pay attention to
the above and select the appropriate value.
e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C
ADJUSTMENT
( Not necessary for LCF )
( Sub-code )
[ START ]
[ Drawer
selection ]
Fig. 3-12
*
Mode
© 2008 - 2011 TOSHIBA TEC CORPORATION All rights reserved
3 - 14
Current value
Enter new
displayed
*1
[ ] + [ FAX ]
( Test print )
value
[ POWER ]
OFF/ON
( Exit )
Advertisement
Table of Contents
