Bfd Configuration Commands; Bfd Detect-Multiplier; Bfd Echo-Source-Ip - HP 7500 Series High Availability Command Reference

BFD configuration commands

The term "interface" in BFD collectively refers to Layer 3 interfaces, including VLAN interfaces and Layer
3 Ethernet interfaces. You can set an Ethernet port as a Layer 3 interface by using the port link-mode
route command (see Layer 2—LAN Switching Configuration Guide).

bfd detect-multiplier

Use bfd detect-multiplier to configure the detection time multiplier.
Use undo bfd detect-multiplier to restore the default.
Syntax
bfd detect-multiplier value
undo bfd detect-multiplier
Default
The detection time multiplier is 5.
Views
Interface view
Default command level
2: System level
Parameters
value: Detection time multiplier, in the range of 3 to 50.
Examples
# Configure the detection time multiplier as 6 on VLAN-interface 1.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] bfd detect-multiplier 6

bfd echo-source-ip

Use bfd echo-source-ip to configure the source IP address of BFD echo packets.
Use undo bfd echo-source-ip to remove the configured source IP address of BFD echo packets.
Syntax
bfd echo-source-ip ip-address
undo bfd echo-source-ip
Views
System view
Default command level
2: System level
127