[Sysname-mst-region] active region-configuration
[Sysname-mst-region] quit
[Sysname] rrpp domain 1
[Sysname-rrpp-domain1] control-vlan 100
[Sysname-rrpp-domain1] protected-vlan reference-instance 1
Related commands
display stp region-configuration (Layer 2—LAN Switching Command Reference)
•
•
rrpp domain
reset rrpp statistics
Use reset rrpp statistics to clear RRPPDU statistics.
Syntax
reset rrpp statistics domain domain-id [ ring ring-id ]
Views
User view
Default command level
1: Monitor level
Parameters
domain-id: RRPP domain ID, which ranges from 1 to 24.
ring-id: RRPP ring ID, which ranges from 1 to 64.
Usage guidelines
If you have specified an RRPP ring ID in the command, RRPPDU statistics of the specified RRPP ring in the
specified RRPP domain on the current device are cleared. Otherwise, RRPPDU statistics of all RRPP rings
in the specified RRPP domain are cleared.
Examples
# Clear the RRPPDU statistics of ring 10 in RRPP domain 1.
<Sysname> reset rrpp statistics domain 1 ring 10
Related commands
display rrpp statistics
ring
Use ring to configure the node mode of the device, the role of the specified RRPP port, and the level of
the RRPP ring.
Use undo ring to remove the configuration.
Syntax
ring ring-id node-mode { { master | transit } [ primary-port interface-type interface-number ]
[ secondary-port interface-type interface-number ] level level-value | { edge | assistant-edge }
[ edge-port interface-type interface-number ] }
undo ring ring-id
76