Slave Switchover { Disable | Enable - HP 7500 Series High Availability Command Reference

Syntax
slave switchover
Views
System view
Default command level
2: System level
Usage guidelines
When the device is operating in IRF mode, this command is not supported. To switch between the
standalone mode and IRF mode, use the chassis convert mode irf command.
Examples
# Manually configure the switchover between the active MPU and the standby MPU.
<Sysname> system-view
[Sysname] slave switchover
Caution!!! Confirm to switch slave to master?[Y/N] y
Starting.....
RAM Line....OK
Related commands

slave switchover { disable | enable }

slave switchover { disable | enable }
Use slave switchover disable to disable manual switchover function between the active MPU and standby
MPU.
Use slave switchover enable to enable manual switchover function between the active MPU and standby
MPU.
Syntax
slave switchover { disable | enable }
Default
Manual configuration of the switchover between the active MPU and standby MPU is enabled.
Views
System view
Default command level
2: System level
Parameters
disable: Disables manual switchover between the active MPU and standby MPU.
enable: Enables manual switchover between the active MPU and standby MPU.
Usage guidelines
When the device is operating in IRF mode, this command is not supported. To switch between the
standalone mode and IRF mode, use the chassis convert mode irf command.
4