Forwarding & Filtering; Unicast Forwarding; Static Multicast Forwarding - D-Link DXS-3326GSR Manual

State <Disabled>
Click Apply to implement changes made.
Forwarding & Filtering

Unicast Forwarding

Open the Forwarding & Filtering folder in Configuration and click on the Unicast Forwarding link. This will open the
Setup Static Unicast Forwarding Table window, as shown below:
To add or edit an entry, define the following parameters and then click Add/Modify:
Parameter
VLAN ID (VID)
MAC Address
Unit
Port
Click Apply to implement the changes made. To delete an entry in the Static Unicast Forwarding Table, click the
corresponding under the Delete heading.

Static Multicast Forwarding

The following figure and table describe how to set up Multicast Forwarding on the Switch. Open the Forwarding &
Filtering folder and click on the Multicast Forwarding link to see the entry window below:
DXS-3326GSR Gigabit Layer 3 Switch
True.
This drop-down menu allows you to enable or disable STP for the selected group of
ports. The default is Enabled.
Figure 6- 28. Setup Static Unicast Forwarding Table window
Description
The VLAN ID number of the VLAN on which the above Unicast MAC address
resides.
The MAC address to which packets will be statically forwarded. This must be a
unicast MAC address.
Choose the desired Unit.
Allows the selection of the port number on which the MAC address entered above
resides.
63