D-Link DXS-3326GSR Manual page 50

Parameter Description
Serial Port Auto
Logout Time
Serial Port Baud
Rate
MAC Address
Aging Time (10-
1000000)
IGMP Snooping
Multicast router
Only
GVRP Status
DXS-3326GSR Gigabit Layer 3 Switch
Figure 6- 4. Switch Information (Advanced Settings) window
Select the logout time used for the console interface. This automatically logs the user
out after an idle period of time, as defined. Choose from the following options: 2
Minutes, 5 Minutes, 10 Minutes, 15 Minutes or Never. The default setting is 10 minutes.
The baud rate setting for the Switch is 115,200.
This field specifies the length of time a learned MAC Address will remain in the
forwarding table without being accessed (that is, how long a learned MAC Address is
allowed to remain idle). To change this, type in a different value representing the MAC
address age-out time in seconds. The MAC Address Aging Time can be set to any
value between 10 and 1,000,000 seconds. The default setting is 300 seconds.
To enable system-wide IGMP Snooping capability select Enabled. IGMP snooping is
Disabled by default. Enabling IGMP snooping allows you to specify use of a multicast
router only (see below). To configure IGMP Snooping for individual VLANs, use the
IGMP Snooping page under the IGMP folder.
Enable to support Multicast router only.
Use this pull-down menu to enable or disable GVRP on the Switch.
37