D-Link DXS-3326GSR Manual page 115

Configure the following Access Rule Configuration settings:
Parameter
Profile ID
Mode
Access ID
Type
Priority (0-7)
DXS-3326GSR Gigabit Layer 3 Switch
Figure 6- 58. Access Rule Configuration window (IP) window
Description
This is the identifier number for this profile set.
Select Permit to specify that the packets that match the access profile are forwarded by
the Switch, according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are not
forwarded by the Switch and will be filtered.
Type in a unique identifier number for this access. This value can be set from 1 to 50.
Selected profile based on Ethernet (MAC Address), IP address or Packet Content Mask.
Ethernet instructs the Switch to examine the layer 2 part of each packet
•
header.
IP instructs the Switch to examine the IP address in each frame's header.
•
Packet Content Mask instructs the Switch to examine the packet header
•
This parameter is specified if you want to re-write the 802.1p default priority previously
set in the Switch, which is used to determine the CoS queue to which packets are
forwarded to. Once this field is specified, packets accepted by the Switch that match this
priority are forwarded to the CoS queue specified previously by the user.
Replace priority with − Click the corresponding box if you want to re-write the 802.1p
default priority of a packet to the value entered in the Priority field, which meets the
criteria specified previously in this window, before forwarding it on to the CoS queue
mapped previously by the user. Otherwise, a packet will have its incoming 802.1p user
priority re-written to its original value before being forwarded by the Switch.
For more information on priority queues, CoS queues, and mapping for 802.1p, see the
102