Ospf Interface Settings - D-Link DXS-3326GSR Manual

See the parameter descriptions below for information on the OSPF Area ID Settings.
The Area ID settings are as follows:
Parameter
Area ID
Type
Stub Import
Summary LSA
Stub Default Cost

OSPF Interface Settings

To set up OSPF interfaces, click Configuration > Layer 3 IP Networking > OSPF > OSPF Interface Settings to view
OSPF settings for existing IP interfaces. If there are no IP interfaces configured (besides the default System interface), only
the System interface settings will appear listed. To change settings for in IP interface, click on the hyperlinked name of the
interface to see the configuration window for that interface.
DXS-3326GSR Gigabit Layer 3 Switch
Figure 7- 31. OSPF Area ID Setting Example window
Description
A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies
the OSPF area in the OSPF domain.
This field can be toggled between Normal and Stub using the space bar. When it is
toggled to Stub, additional fields appear − Stub Import Summary LSA, and Default
Cost.
Displays whether or not the selected Area will allow Summary Link-State
Advertisements (Summary LSAs) to be imported into the area from other areas.
Displays the default cost for the route to the stub of between 0 and 65,535. The default
is 1.
Figure 7- 32. OSPF Interface Settings window
152