D-Link DXS-3326GSR Manual page 218

Figure 10- 4. Rx Packets Analysis window (table for Bytes and Packets)
The following fields may be set or viewed:
Parameter
Unit
Port
Clear
Time Interval
Record Number
Bytes
Packets
Unicast
Multicast
Broadcast
Show/Hide
View Table
DXS-3326GSR Gigabit Layer 3 Switch
Description
Select the unit to display statistics for.
Select the port to display statistics for.
Clicking this button clears all statistics counters on this window.
Select the desired setting between 1s and 60s, where "s" stands for seconds. The
default value is one second.
Select number of times the Switch will be polled between 20 and 200. The default
value is 200.
Counts the number of bytes received on the port.
Counts the number of packets received on the port.
Counts the total number of good packets that were received by a unicast address.
Counts the total number of good packets that were received by a multicast address.
Counts the total number of good packets that were received by a broadcast address.
Check whether to display Bytes and Packets.
Clicking this button instructs the Switch to display a table rather than a line graph.
205