D-Link DXS-3326GSR Manual page 131

These two windows allow you to initialize a port or group of ports. The Initialize Port Table in the bottom half of the
window displays the current status of the port(s) once you have clicked Apply.
These windows display the following information:
Parameter
Unit
From and To
Port
MAC Address
Auth PAE State
Backend State
Port Status
Reauthenticate Port(s)
These windows allow you to reauthenticate a port or group of ports by choosing a port or group of ports by using the pull-
down menus Unit and From/To and clicking Apply. The Reauthenticate Port Table displays the current status of the
reauthenticated port(s) once you have clicked Apply.
Click Port Access Entity > PAE System Control > Reauthenticate Port(s) to open one of the two following windows:
DXS-3326GSR Gigabit Layer 3 Switch
Figure 6- 73. Initialize Port(s) (MAC-Based) window
Description
Select desired unit.
Select ports to be initialized.
A read only field indicating a port on the Switch.
Check the corresponding check box and enter a MAC address for which to initialize
802.1x for. This field is only for the Initialize Port(s) (MAC-Based) window.
The Authenticator PAE State will display one of the following: Initialize, Discon-
nected, Connecting, Authenticating, Authenticated, Aborting, Held, ForceAuth,
ForceUnauth, and N/A.
The Backend Authentication State will display one of the following: Request,
Response, Success, Fail, Timeout, Idle, Initialize, and N/A.
The status of the controlled port can be Authorized, Unauthorized, or N/A.
NOTE: The user must first globally enable 802.1X in the Switch
Information (Advanced Settings) window in the Configuration folder
before initializing ports. Information in the Initialize Ports Table cannot be
viewed before enabling 802.1X.
118