Download Configuration File; Upload Configuration; Upload Log - D-Link DXS-3326GSR Manual

DXS-3326GSR Gigabit Layer 3 Switch
Select the Image ID of the firmware. The DXS-3326GSR can hold two firmware images in its memory. Image ID 1 will
always be the boot up firmware for the Switch unless specified by the user. Information on configuring Image IDs can be
found in this section, under the heading Multiple Image Services.
The TFTP server must be on the same IP subnet as the Switch.
Enter the path and the filename to the firmware file on the TFTP server. Note that in the above example, the firmware file
is in the root directory of the D drive of the TFTP server.
The TFTP server must be running TFTP server software to perform the file transfer. TFTP server software is a part of
many network management software packages – such as NetSight, or can be obtained as a separate program.
Click Start to record the IP address of the TFTP server.

Download Configuration File

To download a configuration file from a TFTP server, click on the TFTP Service folder in the Maintenance folder and
then the Download Configuration File link:
Figure 11- 2. Download Configuration window
Enter the IP address of the TFTP server and specify the location of the switch configuration file on the TFTP server.
Click Start to initiate the file transfer.

Upload Configuration

To upload the Switch's settings to a TFTP server, click on the TFTP Service folder in the Maintenance folder and then
click the Save Settings link:
Figure 11- 3. Upload Configuration window
Enter the IP address of the TFTP server and the path and filename for the configuration file on the TFTP server.
Click Start to initiate the file transfer.

Upload Log

To upload the Switch history log file to a TFTP server, open the TFTP Service folder in the Maintenance folder and then
click the Upload Log link:
Figure 11- 4. Upload History Log window
Enter the IP address of the TFTP server and the path and filename for the history log on the TFTP server.
241