D-Link DXS-3326GSR Manual page 57

To configure port trunk groups, click the Add button to add a new trunk group and use the Link Aggregation Group
Configuration window (see example below) to set up trunk groups. To modify a port trunk group, click the Modify button
corresponding to the entry you wish to alter. To delete a port trunk group, click the corresponding
heading in the Current Link Aggregation Group Entries table.
The user-changeable parameters are as follows:
Parameter
Group ID
Type
State
DXS-3326GSR Gigabit Layer 3 Switch
Figure 6- 9. Current Link Aggregation Group Entries window
Figure 6- 10. Link Aggregation Group Configuration window
Description
Select an ID number for the group.
This pull-down menu allows you to select between Static and LACP (Link
Aggregation Control Protocol). LACP allows for the automatic detection of links in a
Port Trunking Group.
Trunk groups can be toggled between Enabled and Disabled. This is used to turn a
port trunking group on or off. This is useful for diagnostics, to quickly isolate a
bandwidth intensive network device or to have an absolute backup aggregation
group that is not under automatic control.
44
under the Delete