External Redundant Power System - D-Link DXS-3326GSR Manual

DXS-3326GSR Gigabit Layer 3 Switch
Figure 2- 5. Front Panel of the DEM-420X
Take the module and gently slide it in to the available slot at the rear of the Switch until it reaches the back, as shown in the
following figure. At the back of the slot are two sets of plugs that must be connected to the module. Gently, but firmly push
in on the module to secure it to the Switch. The module should fit snugly into the corresponding receptors.
Figure 2- 6. Inserting the optional module into the DXS-3326GSR
Now tighten the two screws at adjacent ends of the module into the available screwholes on the Switch. The upgraded
DXS-3326GSR is now ready for use.
Figure 2- 7. DXS-3326GSR with optional module installed.

External Redundant Power System

The Switch supports an external redundant power system.
11