Ports; Installing The Sfp Ports - D-Link DXS-3326GSR Manual

RFC1757 RMON
•
RFC1643 Ether-like MIB
•
RFC2233 Interface MIB
•
IF MIB
•
Private MIB
•
RFC2674 for 802.1p
•
IEEE 802.1x MIB
•
RS-232 DCE console port for Switch management
•
Provides parallel LED display for port status such as link/act, speed, etc.
•

Ports

Twenty-four high-performance SFP ports for a fiber-optic connection to various network connections, for use
•
over great distances.
Four 1000BASE-T combo ports that may be used in uplinking various network devices to the Switch, including
•
PCs, hubs and other switches to provide a gigabit Ethernet uplink in full-duplex mode.
Two 10 gigabit stacking ports at the rear of the Switch for stacking switches utilizing either a ring or star
•
topology.
An optional module slot at the rear of the Switch to add an optional 2-port 10-gigabit XFP module for
•
uplionking using fibre optic cabling.
RS-232 DCE Diagnostic port (console port) for setting up and managing the Switch via a connection to a
•
console terminal or PC using a terminal emulation program.

Installing the SFP ports

The Switch is equipped with 24 SFP (Small Form Factor Portable) ports, which are to be used with fiber optical transceiver
cabling in order to uplink various other networking devices for a gigabit link that may span great distances. These 24 SFP
ports support full-duplex transmissions, have auto-negotiation and can be used with DEM-310GT (1000BASE-LX),
DEM-311GT (1000BASE-SX), DEM-314GT (1000BASE-LH) and DEM-315GT (1000BASE-ZX) transceivers. See the
figure below for installing the SFP ports in the Switch.
DXS-3326GSR Gigabit Layer 3 Switch
NOTE: For customers interested in D-View, D-Link Corporation's
proprietary SNMP management software, go to the D-Link Website
(www.dlink.com.cn) and download the software and manual.
4