Stp Instance Settings - D-Link DXS-3326GSR Manual

To view the MSTI settings for a particular port, select the Port number, located in the top left hand corner of the window
and click Apply. To modify the settings for a particular MSTI Instance, click on its hyperlinked MSTI ID, which will
reveal the following window.
Parameter
Instance ID <0>
Internal cost
(0=Auto) <200000>
Priority <128>
Click Apply to implement changes made.

STP Instance Settings

The following window displays MSTIs currently set on the Switch. To view the following table, click Configuration >
Spanning Tree > STP Instance Settings:
DXS-3326GSR Gigabit Layer 3 Switch
Figure 6- 23. MSTI Port Information window
Figure 6- 24. MSTI Settings window
Description
Displays the MSTI ID of the instance being configured. An entry of 0 in this field denotes
the CIST (default MSTI).
This parameter is set to represent the relative cost of forwarding packets to specified
ports when an interface is selected within a STP instance. The default setting is 0
(auto). There are two options:
0 (auto) - Selecting this parameter for the internalCost will set quickest route
•
automatically and optimally for an interface. The default value is derived from
the media speed of the interface.
value 1-2000000 - Selecting this parameter with a value in the range of 1-
•
2000000 will set the quickest route when a loop occurs. A lower Internal cost
represents a quicker transmission.
Enter a value between 0 and 240 to set the priority for the port interface. A higher
priority will designate the interface to forward packets first. A lower number denotes a
higher priority.
59