To remove a previously created rule, select it and click the
To set the Access Rule for Ethernet, adjust the following parameters and click Apply.
Parameters
Profile ID
Mode
Access ID
Type
DXS-3326GSR Gigabit Layer 3 Switch
Figure 6- 60. Access Rule Table window
Figure 6- 61. Access Rule Configuration (Ethernet) window
Description
This is the identifier number for this profile set.
Select Permit to specify that the packets that match the access profile are forwarded
by the Switch, according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are not
forwarded by the Switch and will be filtered.
Type in a unique identifier number for this access. This value can be set from 1 to 50.
Selected profile based on Ethernet (MAC Address), IP address or Packet Content
Mask
button. To add a new Access Rule, click the Add button:
104