To configure switch ports:
1. Choose the unit and the port or sequential range of ports using the Unit and From/To pull-down menus.
2. Use the remaining pull-down menus to configure the parameters described below:
Parameter
State <Enabled>
Speed/Duplex <Auto>
DXS-3326GSR Gigabit Layer 3 Switch
Figure 6- 5. Port Configuration window
Description
Toggle the State field to either enable or disable a given port or group of ports.
Toggle the Speed/Duplex field to either select the speed and duplex/half-duplex
state of the port. Auto denotes auto-negotiation between a range of devices, in
full- or half-duplex. The Auto setting allows the port to automatically determine the
fastest settings the device the port is connected to can handle, and then to use
39