Configuring Sdp-Enabled Jdbc Drivers For Dept1_Cluster1; Configure The Database To Support Infiniband - Oracle SuperCluster T5-8 Owner's Manual

Configuring SDP-Enabled JDBC Drivers for Dept1_Cluster1

In ONS host and port, enter a comma-separate list of ONS daemon listen addresses and
■
ports for receiving ONS-based FAN events. You can use Single Client Access Name
(SCAN) addresses to access FAN notifications.
Click Next.
■
On the Test ONS client configuration page, review the connection parameters
11.
and click Test All ONS Nodes.
Click Next.
12. In the Select Targets page, select Dept1_Cluster1 as the target and All Servers in
the cluster
13. Click Finish.
14. Click Activate Changes.
Now you must configure SDP-enabled JDBC drivers for the cluster.
15.
For instructions, go to
Dept1_Cluster1" on page
Configuring SDP-Enabled JDBC Drivers for Dept1_Cluster1
You must configure SDP-enabled JDBC drivers for the Dept1_Cluster1 cluster.
This section discusses the following topics:
"Configure the Database to Support Infiniband" on page 238
■
"Enable SDP Support for JDBC" on page 239
■
"Monitor SDP Sockets Using netstat on Oracle Solaris" on page 240
■

Configure the Database to Support Infiniband

Before enabling SDP support for JDBC, you must configure the database to
support InfiniBand, as described in the " Configuring SDP Protocol Support for
Infinband Network Communication to the Database Server" section in the Oracle
Database Net Services Administrator's Guide, located at:
http://download.oracle.com/docs/cd/B28359_01/network.111/b28316/performance.
htm#i1008413
238 Oracle SuperCluster T5-8 Owner's Guide • May 2016
"Configuring SDP-Enabled JDBC Drivers for
238.