Configure Asr On The Zfs Storage Appliance - Oracle SuperCluster T5-8 Owner's Manual

Configure ASR on the ZFS Storage Appliance

You should see both the Oracle ILOM and the host referenced in the list, with the same serial
number, as shown in the following example output:
IP_ADDRESS HOST_NAME SERIAL_NUMBER ASR PROTOCOL SOURCE
---------- --------- ------------- --- -------- -----
10.60.40.105 ssc1cel01 1234FMM0CA Enabled SNMP ILOM
10.60.40.106 ssc1cel02 1235FMM0CA Enabled SNMP ILOM
10.60.40.107 ssc1cel03 1236FMM0CA Enabled SNMP ILOM
10.60.40.117 ssc1cel01-ilom 1234FMM0CA Enabled SNMP,HTTP EXADATA-SW
10.60.40.118 ssc1cel02-ilom 1235FMM0CA Enabled SNMP,HTTP EXADATA-SW
10.60.40.119 ssc1cel03-ilom 1236FMM0CA Enabled SNMP,HTTP EXADATA-SW
On the Exadata Storage Server, validate the configuration:
7.
#
cellcli -e "list cell attributes snmpsubscriber"
8. On the Exadata Storage Server, validate the SNMP configuration:
#
cellcli -e "alter cell validate snmp type=asr"
The MOS contact will receive an email as confirmation.
9. Repeat these instructions for every Exadata Storage Server in your Oracle
SuperCluster T5-8.
10. When you have completed these instructions for every Exadata Storage Server
in your Oracle SuperCluster T5-8, approve and verify contacts to the Exadata
Storage Servers on MOS.
See "Approve and Verify ASR Asset Activation" on page 219
For more information on the process, see ASR MOS 5.3+ Activation Process (Doc ID
1329200.1).
Configure ASR on the ZFS Storage Appliance
To activate the ZFS storage appliance included in your system, complete the following steps on
each ZFS storage controller:
In a web browser, type the IP address or host name you assigned to the host
1.
management port of either ZFS storage controller as follows:
https://storage-controller-ipaddress:215
or
210 Oracle SuperCluster T5-8 Owner's Guide • May 2016
for those instructions.