M Code; 10.9.1 After Mode - Mitsubishi FX3U-20SSC-H User Manual

FX -20SSC-H Positioning Block User's Manual
3U
10.9

m code

The m code is an auxiliary command to support positioning data in execution.
When an m code turns ON in table operation, 20SSC-H stores the table No. in monitor data as an m code
number, while also turning ON the m code ON flag in status information.
There are two modes for m code, after mode and with mode, and each mode has a different ON timing.
Mode
after mode
with mode

10.9.1 After mode

The specified m code turns ON after the operation.
1. Operation
m code No.
m code ON
m code OFF command
1) When the table No. 0 operation with m code "10" ends, the m code ON flag in the status information turns
ON, and the 20SSC-H stores "10" in the m code No. of monitor data.
2) At m code OFF, the m code ON flag and m code itself turns OFF, and 20SSC-H stores "-1" in the m code
No. of monitor data.
3) At m code OFF, 20SSC-H executes the next table No..
Note
• With after-mode m codes in multi-speed operations and continuous pass operations, the operation does
not continue the table since 20SSC-H suspends the operation until m code OFF.
• With "0" in m code information, 20SSC-H turns to standby mode. With start command or m code OFF
command, the m code turns OFF.
• To turn only the m code ON without performing positioning operation, set "m code" to the operation
information of the table information, and set the m code information.
2. Available m code Nos.
To use m code in the after mode, set m code in the range 0 to 9999 to the m code information.
100
The m code turns ON when the operation of table information is completed.
The m code turns ON when the operation information is started.
→ For details on related setting items, refer to Subsection 10.9.3
Speed
-1
OFF
OFF
Table No.
0
1
2
Content
10 -1
ON
ON
OFF
Operation information
1 (1-speed positioning)
-1
(no processing)
0 (END)
10 Table Operation
m code No.
0 to 9999
10000 to 32767
Time
11
ON
OFF OFF
ON
m code information
10 (after mode)
(after mode)
11
-1
10.9 m code