Mitsubishi FX3U-20SSC-H User Manual page 74

FX -20SSC-H Positioning Block User's Manual
3U
Item
Control data
Override setting
Forward rotation
limit (LSF)
Reverse rotation
limit (LSR)
Mechanical zero
Operation return command
command 1
Simultaneous start
flag
In-process speed
change prohibition
Monitor data
Current address (user)
Current address (pulse)
Zero return
execution
Status
information
End of positioning
Servo status End of positioning
Servo parameter
Extended Function selection
setting C-4
*1. For the user units, refer to the following.
68
BFM number
X-axis
BFM #508 BFM #608
BFM #518 b2 BFM #618 b2
BFM #518 b3 BFM #618 b3
BFM #518 b6 BFM #618 b6
BFM #518 b10 BFM #618 b10
BFM #518 b12 BFM #618 b12
BFM #1,#0 BFM #101,#100
BFM #3,#2 BFM #103,#102
BFM #28 b3 BFM #128 b3
BFM #28 b6 BFM #128 b6
BFM #63 b0 BFM #163 b0
BFM #15080 BFM #15280
8.1 Mechanical Zero Return Control
Y-axis
Specify the ratio (percent) of the actual operation speed
to the operation speed.
Setting range: 1 to 30000(
The 20SSC-H decelerates to stop at this parameter ON
during forward rotation output
he 20SSC-H decelerates to stop at this parameter ON
during reverse rotation output
The 20SSC-H starts the mechanical zero return when
rebooting this bit
The 20SSC-H simultaneously starts the X and Y-axes
operation at the X-axis start command ON.
OFF: The speed and target position change commands
during positioning control operation are valid.
ON: The speed and target position change commands
during positioning control operation are invalid.
Setting range:-2,147,483,648 to
2,147,483,647(user unit)
Setting range:-2,147,483,648 to
2,147,483,647PLS
OFF: Zero return is normally finished.
ON: Zero return is started.
This parameter turns OFF at the start of each operation
/ at errors, and turns ON at normal operation end, but
does not turn ON in STOP operations / in the following
operations even at normal operation end
- JOG operation
- Mechanical zero return (data-set type)
- Manual pulse generator operation
- Variable speed operation
OFF: Motor Z-phase pass after power-on
ON: Motor Z-phase no pass after power-on
0:Motor Z-phase pass when power-on is necessary.
1:Motor Z-phase pass when power-on is unnecessary.
8 Manual Control
Description
×
0.1%)
*1
→ Refer to Section 7.7