FX
-20SSC-H Positioning Block User's Manual
3U
10. Table Operation
10.1
Outline of Table Operation
This section describes the table information setting and table operation motions.
For details on positioning in table operation, refer to the following.
About the table operation
"Table operation" executes preset motion patterns of positioning operations from the table information. By
table operation, 20SSC-H continues the supported positioning operation while also combining motion
patterns. A few positioning operations are available in table operation only.
Positioning operations for table operation only
• Multi-speed operation
• Circular interpolation
• Continuous pass operation
10.1.1 Applicable positioning operations for table operation
• Applicable positioning operations for table
operation
- 1-speed positioning operation
- Interrupt 1-speed constant quantity feed
- 2-speed positioning operation
- Interrupt 2-speed constant quantity feed
- Interrupt stop
- Multi-speed operation
- Linear interpolation
- Linear interpolation (interrupt stop)
- Circular interpolation
- Mechanical zero return
*1.
Continuous pass operation in which interpolation operation is continuously executed is supported.
10.1.2 Types of table information and number of registered tables
Type of table information
X-axis table information
Y-axis table information
XY-axis table information
→ For details on each positioning operations, refer to Chapter 9
*1
*1
*1
→ For details on continuous operation, refer to section 10.10
Number of registered tables
300 tables
300 tables
300 tables
10.1 Outline of Table Operation
• Inapplicable positioning operations for table
operation
- Variable speed operation
- Manual pulse generator
- JOG operation
Table number
0 to 299
0 to 299
0 to 299
10 Table Operation
1
2
3
4
5
6
7
8
9
10
91