Xerox Phaser 6120 Service Manual page 49

4.
Remove the Transfer Belt [3].
Caution:
When replacing the Transfer Belt, use care not to touch the surface of the belt.
A scratchy or dirty belt could result in image problems. Do not over-tighten the coin
screws because you may strip the plastic threads.
5. To reinstall, reverse the order of removal.
6. When the Transfer Belt is replaced with a new one, it is necessary to reset the life counter
in the Service menu, see
7. Perform the Density Calibration in the Quality menu. For information about the density
control, see DENSITY CALIBRATION
Phaser® 6120 Color Laser Printer Service Manual
Entering the Service Menu
on page 3-18.
2-13
Maintenance Procedures
[3]
4139fs2004c0
on page 30.