3.
Unlock three tabs [5] and remove the Waste Toner Near Full Detection Board [6].
Note:
When reinstalling the shield, make sure that no part of the harness is wedged in the
mechanism.
4.
Disconnect the connector [8] of the Waste Toner Near Full Detection Board [7].
Laser (PH) Unit
Warning:
Ensure that the power is turned off and the power cord is disconnected from the printer
before performing this procedure.
Do not attempt to disassemble or adjust the Laser (PH) Unit.
1.
Remove the Imaging Unit. See
2.
Remove the Rear Cover. See
3.
Remove the Right Cover. See
4.
Remove the Left Cover. See
5.
Remove the Front Cover. See
Phaser® 6120 Color Laser Printer Service Manual
[5]
[5]
4139fs2031c1
[8]
4139fs2032c1
Imaging Unit
on page 2-9.
Rear Cover
on page 5-4.
Right Cover
on page 5-6.
Left Cover
on page 5-5.
Front Cover
on page 5-6.
5-19
Disassembly/Assembly Procedures
[6]
[7]