Screw Joints - ABB IRB 1600 - 5/1,2 type A Product Manual

7.4. Screw joints

General
This section details how to tighten the various types of screw joints on the robot.
The instructions and torque values are valid for screw joints comprised of metallic materials
and do not apply to soft or brittle materials.
UNBRAKO screws
UNBRAKO is a special type of screw recommended by ABB for certain screw joints. It
features special surface treatment (Gleitmo as described below), and is extremely resistant to
fatigue.
Whenever used, this is specified in the instructions, and in such cases, no other type of
replacement screw is allowed! Using other types of screws will void any warranty and may
potentially cause serious damage or injury!
Gleitmo treated screws
Gleitmo is a special surface treatment to reduce the friction when tightening the screw joint.
Screws treated with Gleitmo may be reused 3-4 times before the coating disappears. After this
the screw must be discarded and replaced with a new one.
When handling screws treated with Gleitmo, protective gloves of nitrile rubber type should
be used.
Screws lubricated in other ways
Screws lubricated with Molycote 1000 should only be used when specified in the repair,
maintenance or installation procedure descriptions.
In such cases, proceed as follows:
Lubricant
Molycote 1000 (molybdenum disulphide grease)
3HAC026660-001 Revision: C
1. Apply lubricant to the screw thread.
2. Apply lubricant between the plain washer and screw head.
3. Tighten to the torque specified in section
dimensions of M8 or larger must be tightened with a torque wrench. Screw dimensions
of M6 or smaller may be tightened without a torque wrench if this is done by trained
and qualified personnel.
7 Reference information
Tightening torque on page 234
Art. no.
11712016-618
Continues on next page
7.4. Screw joints
below. Screw
233