Keithley 6487 Reference Manual page 218

14-14 SCPI Reference Tables
Table 14-6 (cont.)
STATus command summary
Command
:DISable <list>
:DISable?
:CLEar
Parameters:
<NDN> = #Bxx...x
= #Hx
= #Qx
<NRf> = 0 to 65535
<list> = (100:200, -224) Example of a range and single entry (+100 through +200 and -224).
Notes:
1. Commands in this subsystem are not affected by *RST or SYSTem:PRESet. The effects of cycling power, *CLS, and
STATus:PRESet are explained by the following notes.
2. Event registers — Power-up and *CLS clears all bits. STATus:PRESet has no effect.
3. Enable registers — Power-up and STATus:PRESet clears all bits. *CLS has no effect.
4. Error queue — Power-up and *CLS empties the error queue. STATus:PRESet has no effect.
5. Error queue messages — Power-up enables error messages and disables status messages. *CLS and STATus:PRESet have no
effect.
Description
Specify messages not to be placed in queue.
Read the disabled messages.
Clear messages from error queue.
Binary format (each x = 1 or 0)
Hexadecimal format (x = 0 to FFFF)
Octal format (x = 0 to 177777)
Decimal format
Model 6487 Reference Manual
Default Ref
parameter Section SCPI
(Note 5)