Keithley 6487 Reference Manual page 156

Model 6487 Reference Manual
•
<name> Name parameter — Select a parameter name from a listed group.
<name> = NEVer
:CALCulate:FORMat MXB
<NRf> Numeric representation format — A number that can be expressed
as an integer (e.g., 8), a real number (e.g., 23.6), or an exponent
(2.3E6).
:TRACe:POINts 20
<NDN> Non-decimal numeric — A non-decimal value that can be used to
program status enable registers. A unique header identifies the for-
mat; #B (binary), #H (hexadecimal), and #Q (octal).
*SRE #B10001
<n> Numeric value — Can consist of an NRf number or one of the fol-
lowing name parameters: DEFault, MINimum, or MAXimum.
When the DEFault parameter is used, the instrument is programmed
to the *RST default value. When the MINimum parameter is used,
the instrument is programmed to the lowest allowable value. When
the MAXimum parameter is used, the instrument is programmed to
the largest allowable value.
:ARM:TIMer 0.1
:ARM:TIMer DEFault
:ARM:TIMer MINimum
:ARM:TIMer MAXimum
Angle brackets < > — Used to denote a parameter type. Do not include the brack-
ets in the program message.
:DISPlay:ENABle <b>
The <b> indicates that a Boolean type parameter is required. Thus, to enable the
display, you must send the command with the ON or 1 parameter as follows.
:DISPlay:ENABle ON or 1
= NEXT
Select Mx + B calculation
Set buffer size to 20
Set bits B0 and B4 of Service
Request Enable Register
Sets timer to 100 msec.
Sets timer to 0.1 sec.
Sets timer to 1 msec.
Sets timer to 999999.999 sec.
Remote Operation 9-11