Table of Contents
Advertisement
FX2N-32DP-IF Profibus-DP Interface Unit
Table C-39: FX
Nr.
Parameter Name
00
pulse rate value
(1st)
01
feed rate lower
(2nd)
word
02
feed rate upper
(3rd)
word
03
pulse output format
(4th)
04
rotation direction
(5th)
home position ret.
05
*1
(6th)
dir.
06
DOG input polarity
(7th)
07
count start timing
(8th)
08
STOP input polarity
(9th)
09
STOP input mode
(10th)
10
System of units
(11th)
11
position data
(12th)
multiplication
-1PG (Motorola Format)
2N
Value Setting List
Default: 2000 (07D0Hex)
Default: 1000 (03E8Hex)
Default: 0 (0000Hex)
forward/reverse pulses
pulse/direction
CP value increases with a FP
CP value decreases with a FP
CP value dec. during ret. home
CP value inc. during ret. home
DOG signal active high
DOG signal active low
count z.p.sig.
count z.p.sig.
impulse
STOP operation if input is on
STOP operation if input is off
remaining distance
next position
Motor system
Machine system
Combined system
multiplicator = 1
multiplicator = 10
multiplicator = 100
multiplicator = 1000
Set pulse rate. (BFM #0).
Setting range: 1 ~ 32767
(0001 ~ 7FFFHex)>
Set lower word for feed rate. (BFM
#2).
Setting range (BFM #2, #1):
1 ~ 999999
(00000001 ~ 000F423FHex)>
Set upper word for feed rate. (BFM
#1).
Setting range (BFM #2, #1):
1 ~ 999999
(00000001 ~ 000F423FHex)>
Select pulse output format from the
available options. (BFM #3)
Select rotation direction from the
available options. (BFM #3)
Select the home position return
direction from the available options.
(BFM #3)
Select the polarity of DOG signal
from the available options. (BFM
#3)
*2
while DOG is act.
Select the count start timing from
*2
after DOG
the available options. (BFM #3)
Select the polarity of STOP signal
from the available options. (BFM
#3)
Select STOP operation from the
available options. (BFM #3)
Select system of units from the
available options. (BFM #3)
Select magnification of positioning
data from the available options.
(BFM #3)
Appendix C:
Description
C-45
Advertisement
Table of Contents
