Mitsubishi JY992D77701D User Manual

This manual only describes the specifications for FX
For complete operation, wiring, mounting and programming instructions please refer to the FX
-20GM HARDWARE PROGRAMMING MANUAL, FX PROGRAMMING MANUAL ΙΙ and FX SERIES
FX
2N
HARDWARE MANUAL.
These manuals should be read and understood before attempting to install or use the unit.
1. Reference manual
Refer to the under mentioned manual for details about product installation, and programming.
1) FX -10GM, FX
2N 2N
The installation of FX
2) E-20TP-E OPERATION MANUAL
The operation of the input of the program which uses E-20TP-E and the monitor and the test is
explained.
3) FX-PCS-VPS/WIN-E SOFTWARE MANUAL
The operation program is input using the FX-PCS-VPS/WIN-E software. This manual explains the
operation of the monitor and test functions.
4) FX-PCS-KIT-GM-EE SOFTWARE MANUAL
The program is input via the FX-PCS-KIT-GM-EE. The manual explains the operation of the monitor
and test functions.
The manual in 1) is not included with the product. Please request from the shop where the units was pur-
chased if required.
The manuals in 2), 3) and 4) are included with the product.
2. Outline of the unit
The FX -10GM positioning controller (hereinafter call FX
2N
that enables the positioning control of a stepping motor or a servo motor via the drive unit.
• One FX -10GM can control 1 axis.
2N
• Both dedicated positioning language (cod instructions) and sequence language (basic instructions
and application instructions) are available.
• A pulse generator can be connection.(The manual pulse generators must be an open collector output
type.)
• The zero return operation at each start can be omitted with a servo amplifier with the absolute position
(ABS) detection function.
• The FX -10GM can be used alone.
2N
When an FX -10GM is connected with an FX
2N
troller (here after call PLC), the positioning data can be read/written.
When connecting to an FX
When connecting to an FX
3. External dimensions
87(3.43)
74(2.91)
-20GM HARDWARE PROGRAMMING MANUAL
-10GM and FX
2N 2N
PLC, the FX
2NC
PLC, the FX
3UC
60(2.36)
13(0.51)
POWER
READY
AUTO
ERROR
CPU-E
MANU
Power supply
cable
FX
USER'S GUIDE
-10GM positioning controller.
2N
-20GM and wiring and the instructions are explained.
-10GM or 10GM) is a pulse chain output unit
2N
/FX /FX
2N 2NC 3U
-CNV-IF must be used.
2NC
-CNV-IF or FX
2NC 3UC
FX -10GM
2N
START
STOP
ZRN SVRDY
FWD SVEND
RVS PGO
DOG FP
LSF RP
LSR CLR
X0
X1
X2
X3
Y0
Y1
Y2
Y3
Y4
Y5
-10GM
2N
JY992D77701D
/FX series Programmable logic con-
3UC
-1PS-5V must be used.
Din rail width: 35mm
Weight: approx.0.3kg
Dimensions mm(inch)
-10GM,
2N