FX2N-32DP-IF Profibus-DP Interface Unit
2.2
Mounting
Mounting method for the 32DP-IF is DIN rail mounting or direct wall mounting.
2.2.1
DIN Rail Mounting
• Align the upper side of the DIN rail mounting groove of the 32DP-IF with a DIN rail*1 (c),
and push it on the DIN rail(d). See Figure 2.3.
• When removing the 32DP-IF from the DIN rail, the hook for DIN rail is pulled (e), and the
32DP-IF is removed (f). See Figure 2.4.
Figure 2.3: Attach to DIN Rail
Figure 2.4: Remove from DIN Rail
*1 Uses DIN 46277 <35mm (1.38")>
2.2.2
Direct Mounting to Back Walls
The 32DP-IF can be mounted with M4 screws by using the direct mounting holes.
An interval space between each unit of 1
For mounting hole position of 32DP-IF, refer to section 1.2. Further information about extension
I/O units/blocks can be found in the FX
function units/blocks can be found in each manual.
~
2 mm is necessary.
Hardware Manual. Further information about special
2N
Mounting 2
2-2