Mitsubishi FX2N-32DP-IF User Manual page 123

FX2N-32DP-IF Profibus-DP Interface Unit
Table C-13: FX
Nr. Parameter Name
*2
18 ..channel 1 (offset/
(19th) gain)
*2
19 ..channel 2 (offset/
(20th) gain)
*2
20 Next parameter
(21st) uses EEPROM.
*2
21 ..channel 3 (offset/
(22nd) gain)
*2
22 ..channel 4 (offset/
(23rd) gain)
*1 To RESET the special function block, set both parameters (2&3) to "reset module".
While processing a RESET command, no other parameter will be accepted by the
special function block. As mentioned in the FX
takes 3s. It is not possible to RESET the special function block to defaults and to set the
BFMs 0 to 21 to a non-default value within the same parameter data block.
However, it is possible to send a parameter block to RESET any special function block
that supports the RESET function and afterwards to send a second parameter block to
set the module/s to the desired parameter values.
*2 When changing offset and gain setting value for one or more channels, please set the
values for every channel.
-4DA Extension Configuration (Intel Format)
2N
Value Setting List
no offset/gain setting
change offset
change gain
change gain & offset
no offset/gain setting
change offset
change gain
change gain & offset
DON'T write parameter to
EEPROM
write parameter to EEPROM
no offset/gain setting
change offset
change gain
change gain & offset
no offset/gain setting
change offset
change gain
change gain & offset
Description
Select gain/offset adjust setting for
channel 1 from the available options
(BFM #8).
Select gain/offset adjust setting for
channel 2 from the available options
(BFM #8).
The 22nd and 23rd parameter use
EEPROM. Select "writing to
EEPROM" setting from the available
options.
Select gain/offset adjust setting for
channel 3 from the available options
(BFM #9).
Select gain/offset adjust setting for
channel 4 from the available options
(BFM #9).
-4DA user's guide the EEPROM access
2N
Appendix C:
C-17