Canon Staple Finisher-H1 Service Manual page 25

2
Technology > Processing Tray Unit > Alignment / Shifting Operation
● Alignment Operation in Staple Mode
(1) After lapse of the specified time since detection of paper by the delivery sensor (S2),
the front and rear alignment plates move to the standby position (Front alignment plate:
Home position + 2 mm; Rear alignment plate: Paper width + 10 mm).
• Standby position of central reference (when the paper width is 200 mm or more)
Half of Paper Width
+10mm
Middle of Feeding Path
2mm
Front Alignment Plate Home Position
• Front standby position (when the paper width is less than 200 mm)
Half of Paper Width
+10mm
Middle of Feeding Path
Half of Paper Width
+10mm
2 Technology > Processing Tray Unit > Alignment / Shifting Operation
(2) After lapse of the specified time since detection of the paper's trailing edge by the
delivery sensor (S2), the front and rear alignment plates move to align paper.
• Staple alignment position (when the paper width is 200 mm or more)
• Front alignment position (when the paper width is less than 200 mm)
F-2-19
F-2-20
The position that aligns
paper by the front and
rear alignment plates
2mm
Front Alignment Plate Home Position
20mm
Paper
2-13
Paper
F-2-21
F-2-22
2-13