Canon Staple Finisher-H1 Service Manual page 60

4
Parts Replacement and Cleaning Procedure > Motors > Removing the Stack Tray Shift Motor (M8)
CAUTION:
When attaching the stack tray shift motor, check that the front and rear rack gear plates are in phase with the gears.
CAUTION:
When attaching the stack tray shift motor, tighten the 3 screws in such a manner that the clearance
between the motor support plate and side plate is about 0.5 mm to 1.0 mm.
Approx. 0.5mm to 1.0mm
4 Parts Replacement and Cleaning Procedure > Motors > Removing the Stack Tray Shift Motor (M8)
F-4-49
F-4-48
4-22
4-22