Tray Auxiliary Guide Operation - Canon Staple Finisher-H1 Service Manual

2
Technology > Processing Tray Unit > Tray Auxiliary Guide Operation
(3) The front and rear alignment motors (M4 and M5) operate to move the front and rear
alignment plates, thus aligning the paper in the width direction. (In the illustration below,
the paper is aligned with reference to the central reference position.)
Operations described in (2) and (3) are repeated for each sheet.
Rear Alignment Plate
Front Alignment Plate
2 Technology > Processing Tray Unit > Tray Auxiliary Guide Operation
When two or more sheets with a length of 150 mm or more are stacked on the processing
tray, the tray auxiliary guides slide out to prevent misalignment of paper due to curl.
The tray auxiliary guides are driven by the tray auxiliary guide motor (M6). They slide out
when the inlet sensor (S1) detects paper and they slide back when paper is delivered by the
gripper.
The home position of each tray auxiliary guide is detected by the tray auxiliary guide HP
sensor (S6).
F-2-13

Tray Auxiliary Guide Operation

Tray Auxiliary Guide
2-9
Tray Auxiliary Guide
HP Sensor (S6)
Tray Auxiliary Guide
M6
Tray Auxiliary Guide Motor
F-2-14
2-9